The product says it programmable but it’s not. Had I have known that I would have bought something different. I’m not very happy with this pitches.
Not sure if I got a bad set, but within 10min of mellow driving the ball joint on the top of the driveshaft broke
Was made terribly cant put hing pins in the bottom cause the hole is to small
I don’t know what happend when the were being made but the holes are to small so I can’t put the hinge pin in
They seem to work good and have held up for my first few runs so far in my Granite V3. I’ve done some fairly big jumps and landed on the power a few times from backflipping and such. They are definitely noisier than stock (because they’re steel) and there is a little step down on the diff input/pinion that I put an E clip on to prevent the input gear from pulling through the bearings and contacting the diff planetary housing under braking or reverse. Not sure if it was 100% necessary but it seemed like an issue that needed fixing to me. After one run the rear diff feels a bit clicky when rotating the planetary gears only by hand but hasn’t gotten worse since. They do feel like they’re filled with fluid too, the differential action is consistent. Video is of me moving the internal planetary gears but not the ring and pinion or the motor. Again i’m not too sure what is acceptable or not with these but for the price, i’d like to see better.
